Ray
Assuming your new compressor is the same as the old York compressors used by Ford, there's no special tool required. There are 3 steps to remove the clutch:
(1) Remove the belt, energize the clutch
(2) Loosen & remove the clutch mounting bolt & washer
(3) Install a 5/8-11 bolt in the drive shaft hole, tighten the bolt which will bear against the compressor shaft until the clutch pops loose from the shaft.
-G
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.