Skip to main content

Reply to "Bearing retainer removal to press out rear hub? (Pics)"

Yes, you need to press out the axle first as described at end of item 7 & Fig 5. as you setup, then you will have access to remove the bearing retainer and press out the bearings.

That is an aftermarket brake hat/disc, most competent mechanics would never put it back together without new bearings when doing the brake upgrade, so question is have the bearings failed again and if so why? Check the axle and hub carrier closely as well as the bearing spacer end surfaces and outer spacer.

Last edited by joules
×
×
×
×