I was wondering if anyone can give me an opinion on this CompCam custom cut CAM they came up with for me. I'm in the middle of installing it so now is the time to change it out if I need to...
110 Lobe Separation Dur.@.050, 230 Int., 236 Ex. Degrees. Lift .624" Int. and .627" Ex.
Driveline specs: 10.5:1 Compression, Iron 4v Closed Chamber, KB Flat Top Pistons, Hydraulic Roller Lifters, Roller Rockers, Throttle body injection, Holley Street Dominator Single Plane intake, 180 Exhaust. External vacuum booster 3.77 Gear ratio.
My concern is the lift, CompCam seems to think this will be perfect for the street with my current configuration. I figured they should know something about CAMs...the only problem is I talked to a few other CAM cutters and they all had different numbers when it came to my config. But nobody had any CAM cores to cut due to supply chain issues...CompCam had a few cores left so I went with them. CompCam had the highest lift calculation out of all the other custom cutters.
Any recommendations/opinions would be greatly appreciated. Thanks!