Skip to main content

Reply to "Rear Chassis cross member repair"

Thanks Larry - I was firstly thinking of doing exactly that but the existing lower surface has been  beaten in by about 5- 15 mm in the middle through the tender mercies of the Mad Mechanics Guild. I would be guaranteed of a gap between the member and the plate. And I did not want to create a new problem solving the old by just sealing it up.

Perhaps a combination ?  I could fold the RHS end up - and  seal weld the ends in before it is put into the recess? Then the RHS is inserted only to be flush with the pinch weld and sealed in at the ends and along the pinch weld ? So the entire bottom surface is 1/4 lower ?

×
×
×
×