Reply to "Rear upper ball joints"

PercyMember

Bosswench

I have new boot seals and will install shortly. I was going to install Zerks on the lower pivot shaft area on the uprights while I have the shafts out , as its pretty straight forward when everything is apart.

Where do you normally locate the Zerk fitting on the ball joint and do the ball joints have to be removed before the mounts are drilled to take the fitting?

I have plenty of Zerk fittings - just trying to match the thread type for the holes. I think its a NF thread ?

11/8/208:43 PM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...