Skip to main content

Reply to "Roll Cage"

Here are some drawings of the parts required to make the main rollbar hoop.
I bolted this down to the inside of the rocker panel, three M10 bolts per side & a 6mm thick load plate within the rocker panel.
Also it’s bolted to the top shoulder seat belt mount.
So it’s firmly fixed in place & greatly stiffens the chassis.
This rollbar fits in snugly & follows the internal contours.
I run a high back seat & it’s not possible to hit my head in the event of a rollover.
The cross tube follows the bottom of the rear window.
Both items need the tube lengths trimmed to fit.
For the rollbar hoop the ends of the legs are sliced at an angle as the inside of the rocker panels are at an angle.
Sorry, I don't have dimensions of the overall rollbar height or the mounts.
We trimmed the barwork to fit the inside of the car by putting the rollbar into the car, centralising & measuring/marking, then removing & cutting.
Bit of trial & error on the fitting side of things.

regards,
Tony.

Attachments

Images (1)
  • PANTERA_ROLLBAR
×
×
×
×