Skip to main content

Reply to "Suspension Lift Kit"

Thanks for the info P.S. I'll try and copy the info from the webpage on this post and see what happens. Usually the script copies, but I hope the schematic also goes thru to the BB. Well, the schematic didn't go thru, but you can easily find it now on this link I'll post again:
http://www.accessconnect.com/air_lift_compressor_kits.htm

Features and Benefits Dual Gauge Load Controller I, P/N 25651 (shown in photo above):

Fully independent to allow for individual changes to help correct body roll and rock.

Individual controls allow for separate pressures in the left and right air springs, letting you level the vehicle side-to-side in the rear.

Corrections for as much as 3"-4" can be made from side-to-side in order to level the vehicle. This is particularly helpful when leveling your RV on a campsite.

Air adjustability right from the dash of your vehicle, up to 100 p.s.i. for maximum roll stability.

Improved handling and cornering on rough uneven roads, sharp curves, high and cross winds, and lane changes.

One year limited warranty. #25651 Load Controller I - Dual Gauge $269.90


SmartAir Automatic Leveling Systems



This automatic leveling system uses a position sensor along with an ECU to maintain a preset vehicle ride height.

The system is comprised of a magnetic height sensor/ECU, a bracket mounted magnet, solenoid valve, relay, air compressor, and an interconnecting wire harness. This system is combined with the previously installed air bags.

The height sensor / ECU is mounted to the vehicle frame and the magnet is mounted to the axle or leaf spring. When load is added to the vehicle, the magnet rises above the ECU centerline (as the suspension is compressed). If the magnet maintains this position for a minimum of 25 seconds, the ECU will turn on the compressor via the relay adding air to the air bags. Air is added until the magnet is re-centered, restoring the vehicle to its preset ride height.

When load is removed from the vehicle, the magnet falls below the ECU and energizes the solenoid valve. This allows the air to escape from the air bags until the magnet is re-centered and the reduction in load is accomodated.
An optional kneeling system can be purchased which includes a dash mounted rocker switch. This system works to manually exhaust air from the bags when a lower vehicle is needed while parked.

Part# 25415 Single System $289.90
×
×
×
×