Skip to main content

I tried to install my Edelbrock Performer intake today with the turkey pan and side gaskets. I could get 6 of the 3/8s bolts in only and they didn't turn freely. I removed the pan gasket and it fit perfect. My block has been decked and the heads have been surfaced. The geometry of course is not the exact same but the surfaces should mate right ? All the Aussies that are running the 2V heads don't use a pan gasket , they use a FP1240 gasket set. Does the FP 1240 fit the 4V heads? Has anybody had this issue?

Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×