Mine is shot. I tried to clean it and it fell apart. Looks like it has been extended. Any recomendations? Thanks Bill
Attachments
Images (1)
Original Post
Replies sorted oldest to newest
Why not use this from Summit? http://cgi.ebay.com/ebaymotors/Trick-Flow-30004-Overflo...ksid=p3756.m20.l1116
...those tanks are way too small and won't hold near enough! I know because I use one for an Oil Breather Tank...
...and they are even too small to be used for a breather tank...
Marlin.... what do you think about the tank Lengthing is there a center cection added? expantion? I took this off 1362.
...It looks as if someone has repaired it, and may have added a couple of inches...
I guess I'm going with this home made tank a racer friend gave me. It does not have a cap on top. But this tank mounts lower than the swirl tank that has the pressure cap on it. The cap that was on my corroded tank was just a cap, no spring just a rubber gasket and some Italian writing on it. It is about the same size. Any body see anything wrong with this?
Attachments
Images (1)
Bill why don't you just buy a stainless replacement tank from Hall Pantera?
Hey Bill,
I've got a stock overflow tank that had a few rust holes on top that a friend of mine repaired and repainted for me a while back. Think it might work for you?
Michael
I've got a stock overflow tank that had a few rust holes on top that a friend of mine repaired and repainted for me a while back. Think it might work for you?
Michael
again! thanks to this site and the great Pantera community... I hooked up wit Dan from Texas and he sold me a nice factory tank! In fact it is already installed! Thanks to all yall' It's going to look great next to my polished intake..MTC