Skip to main content

team, looking for some advice before I launch this project. When I pulled 4072 out of winter sleep my OEM gas pedal snapped in half. I ordered a new one but would like to ask the team, can I just remove the old pedal arm from under the dash or do I have to remove the entire pedal assembly with brake and clutch to replace? Looking at the schematics it looks like I could remove my seat and tap out a retaining pin on the pedal??? Thanks

Original Post

Replies sorted oldest to newest

Dear Dave,

            My pedal also snapped in two during a spirited acceleration ramp launch.

            It was straightforward to remove, take it to a welder and have the two aluminum pieces made into one again.

           Replacement back into position was the reverse of removal. No big deal.

                            Warmest regards, Chuck Engles

 

 

Perfect yep used a snap ring tool and got it off great. Wrestled to get the pin out of the old pedal but with a lot of wd40 and a rubber mallet it cam out. Realigned the pin in the new pedal and put snap ring on. Trouble now is trying to get the pin in the hole by the firewall. Ugh very little clearance to use a hammer. Even with the brake stopper removed. Any suggestions? I love this forum for answers.......thanks dc

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×