Skip to main content

3406 is in need of a new rubber bellows for the cabin side of the clutch master cylinder.  Early style without the effort reduction linkage.

Was supplied with a new master for a later car with the reduction linkage.  Told to swap the pushrods and it should work fine. I believe it will be just fine, but the rubber boots are not interchangeable.

Does anyone know where to source a proper bellows for the early cars?

If I can't find the right one, I suppose I could use DOT 5 silicone fluid in the clutch hydraulic circuit and run without one. That would limit the tendency to absorb moisture at the back of the m/c bore. Grit and dust might be a problem.

Attachments

Images (1)
  • IMG_6492
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×