Single Pod dash wanted

I have one. I located one when I was planning on converting my Pre-L dash, but ...

It came out of a USA GTS.
Contact me via admin@provamo.com if interested,
and I can locate some pics. It has main gauges in it now that I was intending to pull out.
Make me an offer.

Chuck

I have a very nice one also.
Let me know if you are interested.

Thanks,
Ron
rfmccall@comcast.net

Send me some pics and the details, hammer-99@optonline.net. Yup, I'm interested.

I think I can transfer virtually everything, gauges, switches, idiot lights, etc, I need from my dash now? So if that makes it easier...

PanteraDoug,

Not to insult your intelligence, but it may not be as easy as swapping stuff (in case you didn't know, but you might be fully aware).

If you have a dual-pod, it's not a simple swap. You need the single-pod specific HVAC, console, and install two small brackets where the A-pillar meets the front body, one per side. Then, the shift/heater tube tunnel isn't set up to accept the dual-pod specific console, so you'll need to install brackets.

How do I know? I have a car that should have a dual pod dash, but the previous owner installed all of the parts and some body panels from the donor '74 car. So, I have mostly '74 car parts and a dual-pod dash that doesn't fit. I'm either going to find a single pod dash or buy Wilkinson's carbon fiber version.

I'm not insulted at all Corey. I'm always learning.
I talked to Steve Wilkinson about this swap. He told me I can use my console. The defroster ducts need to be changed but the tubing to them can be adapted with hose from the existing.
He didn't say anything about the brackets though.
A little fabrication on my part isn't that big of a deal for me. I do it all the time for my own work.

Steve told me that the consoles weren't the same and wouldn't look good together, but what do I know? The brackets are necessary, both the dash and the console (if you get a newer console).

He didn't tell me that the HVAC could be re-used with a bit of work, but I already have the right one, so it didn't matter.

Good luck!

The plates are included from both Hall and Precision. One of these two seems to be the source. I went with Halls.
Most of the used ones need to recovered anyway. Why pay for something that needs to be redone?
They are $600 new.

Here's the link.

http://hallpantera.com/cgi-bin...ntera-inc&item=21214

i have a box full of nos mounting brackets if you need them..mikedmayberry@hotmail.com