Very interested in the answer here. I was replacing my slave cylinder and realized there was no spacer. The prior owner had just used a standard bolt to attach the bell housing to the engine. I ordered a spacer from a vendor which measured 2 5/16” but there still appears to be a gap between the bracket and spacer of 1/2”. I am wondering if the spacer from the vendor is too short or some mod has been made to my car. Does anyone have easy access to measure their spacer? Thanks. Shashi
I was refreshing a windshield washer motor this evening and discovered a broken magnet in the case. Does anyone have a non-working parts motor with which they are willing to part. Actually, I only need the motor's case to which the magnets are attached.
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .