Skip to main content

Replies sorted oldest to newest

It crosses the whole block inside the water chamber



By observing more carefully to take the photos I noticed that there is not one but three per cylinder bank, we can see the ends on the gasket plan.



The lower end enters in a boss.



The hypothesis of reinforcement of the core in sand or of metal rods which served to position the core in the mold is perhaps the correct one, but I am not sure because the ends would have melted during the casting and we do not would see more trace on the gasket plan. It still seems to have been added after the foundry.

??????????

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×