Reply to "3785 Gets a 400 swap, fabbed 180's and fabbed mufflers"

pittcrewOwner etc. of 3785

I took them back apart and hole sawed the ends I used a 2 ½ hole saw for the inlet side and a 2 3/8 for the outlet side.

The tips I used are Hooker they are 2 ¼ inlet and 3 inch outlet.

These are the same tips midenginemike used in his muffler thread here.
http://pantera.infopop.cc/eve/...562/m/4850059725/p/1

The tips are slash cut but the angle is very shallow so I measured the original Ansa tip slash cut to see what the difference was.
I liked the steeper angle of the Ansa’s better so I decided to match it.

I marked the tips for the new angle and cut out the metal with a cut off wheel. I put them on a belt sander to clean up the edges. Here is a before and after comparison.

Here are all the parts lined up ready to begin building the fixture to weld the tips to the ends.

4/18/096:09 PM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...