Not sure where I got this....
The recommended alignment settings for the Pantera suspension listed in the de Tomaso Pantera Technical Service Bulletin Number 5, Article Number 33 have + or - specs and can be adjusted within the spec for your driving requirements.
Factory recommended alignment settings:
Front Settings
Camber, 1/8 degrees neg to 1/8 degrees pos.
Caster, 2-3/4 degrees pos.
Toe-in, 1/8"
Back Settings
Camber, 3/8 degrees neg to 5/8 degrees neg
Toe-in 1/8" to 3/16"
From: Mike Thomas
Pres., Panteras Northwest
Yellow '74 #6328
Here are the stock specs as I received them a while back from one of our folks. Just had 6328 reset and it drives wonderfully.
Front Camber: -1/8 deg
Front Caster: +2.7 deg
Front Toe-in: 1/8"
Rear Camber: -3/8 to -5/8 deg
Rear Toe-in: 1/8" to 3/16"
Recommend as much front caster as you can get though and if you like to corner hard, -1/2 degree negative camber in the front would be advised.
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.