Skip to main content

Reply to "Air Ride problem"

Thanks for the info. Initially the car wouldn’t raise & no click noise at the value block but the car would lower fine with click at the valve block. Then I switched coil 1 & 2 because looking at the photos above these two look like they are on the supply side of the block to let air in and 3 & 4 look like they are on the exhaust side to let air out. So now I hear a click at the valve block when I press the up button but the car doesn’t raise up. Looking at the video link I assume the click I hear is the sound of the valve opening when I activate the coil (not the coil itself making the click). I have the coil in the #1 spot removed from the valve stem right now and am wondering if I could try the up switch with the coil just sitting there? That would leave the intake coil in place at the #2 spot. Then if I hear a click I assume the coil at the #2 spot works. If I could get #2 off again I could remove that and leave #1 in place too. Would it be safe to operate the switch with a coil removed from the stem but still getting current from the switch?
×
×
×
×