quote:That looks nice and snug
Actually, that photo is the cardboard template. I did the final in a thin aluminum. I laid a bead of black 50 year latex caulking where the shield came close (held off about 1/16" from actual contact) and two pop rivets on the straight left side held them in place very well. I then applied another bead, finger smoothed, of caulk along the edges on the outer surface. Let it dry and sprayed rattle can undercoating over the whole shebang.
quote:Were those stock?
No, not stock. But they should have been.
Larry
Here is finished shield with undercoating.
