This was set up so the blinker switch was just always left on the "low beam" position, flipping to high beams simply turned the lights off.
Roger told me to "just use the high beam wire, and switch the blinker toggle to "high beams", done deal.
The problem is, as I'm on the phone with Roger, he's telling me to switch one of the wires on the 3 pin plug (high beam wire) and as he's telling me this, I'm holding a TWO PIN plug in my hands, and there is no 3rd high beam wire to use.
The light is also just a single element light, so just 2 wires I'm working with here.
Roger suggested I remove the front wheel, and then I'd be able to easily follow the loom all the way from end-to-end, so that's my next move.
quote:Originally posted by bdud:
Mike I am not sure what 2 wire plug you are checking. Is this the plug that you get to from under the wing (fender) going to the headlamp? This should be a 3 wire plug, ground, low and high beam.