Reply to "Brake Light Pressure Switch & Turn Signals"

Yes, but thanks for the thought. Everything helps !

Here's what I have so far.
I brought my car over from Europe. The previous owner did a lot of weird things with the wiring which I have been slowly straightening out. This I believe will be the last of it.
I have 2, yes 2 emergency flasher switches in my car. One in the dash left side of the steering wheel, the round one you push in, and another one in the console, a toggle switch at the bottom of the console. Guess one just can't be too careful.
Disconnected all the wiring to the one in the console.
Now the emergency flasher button on the left side of the dash works and makes the front turning and rear turning signals flash. Like it should be, yahoo.
However.....
With Lights on.
PASSENGER SIDE;
Head Light: OK
Tail Light: OK
Rear Turn Signal: OK
Front Turn Signal: OK
Front Parking Light: (also the turn signal) Not on.
DRIVERS SIDE;
Head Light: Not on.
Tail Light: Not on.
Rear Turn Signal: OK
Front Turn Signal: OK
Front Parking Light (also the turn signal): OK

Any Idea's ?

The fuse panel in the interior, passenger side. 10th fuse down was blown. It was an 8 amp. Replaced it with another 8 amp, blew again. Looking at the wiring diagrams, it shows this should be a 30 amp fuse. Just want to be sure before I put a 30 amp fuse in it and start melting my wiring. Can someone please verify this for me....

Getting close....Thanks guys ! Appreciate the help very, very MUCH !