Reply to "Brake Light Pressure Switch & Turn Signals"

Kevin,
That was it brother ! You're the man !
And with the help of Charlie McCall by sending me the 1980 series fuse panel diagram, it has been figured out.
When I was working with the license plate light assembly, the right electrical tab broke off. I soldered it back on put it back together and that's when things started to happen.
This morning I dropped it from the chassis and just let it hang.
Put 2 new 8 amp fuses in #9 & 10 and turned on the lights, didn't blow any fuses. Everything worked as far as lights and turn signals except the drivers head light didn't come on. Ran a bridge ground wire from the black wire to each head light and both now work. Appears I have a break in the ground somewhere in the front harness that goes across the front end. Which I'm not sure how that can be since the turning/running light ground runs through the same harness and are both working.... I'll track that down and tape up the ends of the license plate light and that should be that.

A BIG THANK YOU to all of you that responded with bits and pieces of help and knowledge. You too SOB Bill....You guys are the best ! (no matter what anyone says).

It's a pleasure knowing you guys and this adds much to the enjoyment of owning a Pantera. Thanks again to one and all !
Coz