I am working on mounting a second set of stock calipers on the rears.
I measured the threaded part of the hose that goes into the caliper - it's .488" (this is what I thought was 10mm x 1.25)
The AN3 Threads were .472", and it didn't seem like they had the same thread pitch....
It doesn't seem like the AN-3 fitting has as much bearing surface in the caliper hole... (just from a quick test)
Thanks -
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.