...One more tip: When you get to the point where you use a drill motor and Oil Pump Drive Shaft to 'PreLube' Your engine Bearings; have a Pressure gauge mounted at the port at the extreme rear of the block, plug all other ports such as the port nearest the oil filter. Then when you see the pressure come up on the gauge, look down into the Distributor hole and you will see that stream of oil shoot out of your drilled hole! Good-Luck with it!...
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.