JT Thanks
I figured it was a stupid question, but need conformation. Searched the forum to see if anyone had the same experience, but found none.
Guess I'm one of the few w/o the reduction kits.
Switched the push rods and all is good. This is the second time I've replaced the MC, (over the years),and the time before the push rod was the same length, last time was alloy type, this one from PPF was cast iron, a dead ringer of ordinal. With two seals, the alloy one had only one seal. I would of switched it anyway, but much appreciate your response, thanks again!!
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.