Reply to "Electric Power Steering"

EZ Uses a NSK motor system. Not sure what it is out of, but its a tiny system, even smaller than the Corsa B and C systems. Great for packaging but the down side small system = small power.

...see this is why I dont like "kits" you can have VSS adjustment or pot adjustment with EZ. I want both (insert colorful metaphor here), even better I rather program a curve via the Arduino....if that's possible... I need to read up on that little chip.

Doug, the pantera is standard 3/4DD shafts, which makes life easy since you can get them anywhere. You can see the GM computer in the photos (big gray box), I had to relocate it from its stock location, but its not huge and yes you need it.

Let me know if you're serious and I can help you out with the shaft sizes, joints, cut planes, U-joints, etc. I still have the templates for all the custom bits as well, since I was considering kitting this out with the new steering rack at one point, but seems like no one is interested in ~400 dollar power steering.

If you had directions and templates, I would think its about a 10-15 hour job to fab and install everything. This is assuming you do everything including motor mods, wiring, fab the chassis brackets etc, and of course that you can weld and cut some metal, this motor is far from a bolt in.