Reply to "Electrical Problem HELP"

angelobMember

This might be a place to check out.

Ignition problems

Since you have had electrical gremlins, i.e. Alt, regulator, ammeter, ign switch and a replaced starter. I would:

1. Walk away from it for a bit to get calmed down.
2. Research the way the wiring is supposed to be.
3. Go back and methodically confirm wiring for each component throughly one at a time. Shotgunning for a solution just makes headaches.
4. If you are running an MSD 6AL or like system, it will not run at 6 volts. IF your 6 volt reading is during cranking I would back trace that wire to its source. resister or resister wire come to mind..
5. Where did you place your jumper? Both sides. If you jumper supplied a full 12 volts where it was supposed to be on a 6AL you should have run...unless you had a bad module in the distributer....I just replaced one, same symptoms. What ignition system you running? I don't remember reading that.
5. Be methodical, it helps.

Angelo

8/1/104:06 PM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...