Husker
I have the aluminium not composite Brembo units and I estimate they are around 600-800 gm each. Not heavy at all.
David
Those two part hubs and rotors are outstanding - where did you get them ? In fact the entire setup looks astonishing. Are the lower wishbones stock - hard to see?
I am manning up to strip the entire back suspension back out for a full bearing , bush , lower shaft replacement exercise . On top of that I am going to replace all the wheel studs as the only time you can do it on the one piece hub is when the axle is pulled and in pieces. It looks like you could just take the top hub assembly off yours and pretty well do whatever you like .
Is the offset on the wheel the same as the OEM ?
Thanks for sharing the photo.
Percy