Reply to "Flashers / Turn Signal Don't Work... Any Electrical Experts?"

Rocky,

It sounds like one set of contacts in the hazard switch may be bad. Verify that you have +12v on the green wire (pin 30), and on the red wire (pin 15, key on) at the hazard switch. You can also check this at the nylon connector. If you have +12v at both of those pins, and no power on the yellow wire at pin 30, then the hazard switch contacts for pins 15, 30, & 49 are bad.

Depending upon which wire loom your car has, this circuit exits fuse #8 via a yellow or violet wire. There are two green wires that are spliced into this yellow or violet wire. One green wire goes to the hazard switch pin 30, and the other green wire goes to the wiper and washer switches.

Try adding a jumper wire between pins 15 & 49 on the hazard switch. This will allow the turn signals and hazard lights to work (key on for both). Next, move the jumper to pins 30 & 49. This should allow both the turn signals and the hazard lights to work with the key off. If that works, then some of the hazard switch contacts are bad.

John