Attached is a pic of the rear drivers side lower frame. Inside the red rectangular container, you can see that at some point in its life, the car's frame has been indented/compressed when the skid plate was bolted on too tightly.
If this is no big deal (ie, not being a structural engineer, I have no idea if this is actually a frame integrity issue), I won't worry about it. I will just clean up frame and POR-15 it to prevent rust.
However, if need be, I can craft 4 appropriately sized pieces steel and weld them around all four sides of the damaged area.
Thoughts?
Thanx
Mark
NOTE: this pic shows pretty well how the frame was modified at some point to accommodate the Boss 302 motor.
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.