Rubber seals in previous input taken care of....
Does the following flow of rebuild make sense? Any major muscle movements left out?
- Check all wire continuity
- Refresh front suspension and refresh steering
- Brake rebuild/overhaul with new brake lines
- Clutch lines rebuild
- Rebuild doors
- Refresh interior
- Run rebuilt motor with all cooling and ignition from car on test stand
- Refresh all hoses
- Move motor, cooling, ignition from test stand to car
- Lights/horn/electrics, grate, trim on front end
- Lights/electrics/remote starter/battery on rear end
- Install exhaust system (possibly rebuild new exhaust like Dick Ruzzin's over the top bundle of snakes due to width of Boss 302 heads)