Thank you all for your information.
Following your advices, I measured :
- the gap : 0.040" gauge slides between the disc and the flywheel
- the slave cylinder stroke : 16.5 mm.
At first sight, nothing especially out of adjustment...
Nonetheless, I noticed that the angle value between the clutch axle arm and the slave cylinder axis was greater than 90°, even at full stroke : so, I rotated the arm by one notch.
I'll check the new gap tomorrow - maybe I'll need to lenghten the rod - but I'm not sure that it would significantly improve
I'll keep you posted.
Matt
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.