Reply to "Headlights not even"

Note also in the sketch above there are two plastic bushings on both ends of the actuating bar. These bushings are often worn thru and fall out. If both bushings on one end are gone, the bar probably sags on that end, besides causing squeaks during headlight raise/lower. This might complicate any leveling tweeks. The bushings can theoretically be changed, but it appears to be a LOT of work. FWIW, the headlight bar was installed before both the outer fenders were welded in place. I'm told that to completely remove a stock headlight bar, it must be cut in three (3) places before the chunks can be pulled out.