I used a couple pieces of 1/8 x 1" flat stock that were a little larger than the axle width. I had a piece of round stock just a little smaller than the width of the axle. In the press I slipped the flat bar through the top bearing and placed it on the bottom bearing. Then I used the round stock to go through the upper bearing and pushed the lower bearing out that way. Didn't take much pressure. I have an old 12 ton press that looks bad but works.
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.