Reply to "hyd roller cam with chi 3v heads"

Woww, I was just in the middle of that discussion as I (try) to rebuild 351 C Stock(+) (3.5, 4.010 today!! 9.206) living in Germany (a still abundant place for US blocks/motors). Intent to go for flat top Ross one pocket (teams recommendation, but 4.030!!) and Trick Flow Heads PowerPort190 (still not bought).
I am building a STREET CAR for high speed (still) German Streets (limited by 15" Rim/tire options unfortunately). so 5th gear will be used...(smile)

- Like the option from George on the mentioned cam (so far was looking for the older recommendation on Crane 529541). and 5500rpm are good enough..(smile)

1) is this recommended cam Crane #529551 a good fit for Trick flow PowerPort190? and my usage pattern?
2) what will be roughly the dynamic compression ration? Static is app 10.25 per tool (4.03, 3.5, 0.40. 0.035, 62cc, 1 pocket +1.5), pump gas obviously

Bore issue:
- the Block is very good and could use only honing to 4.010
-Heads are open chamber Cobra Jet (ref the other thread from Larry & George..cheaper to replace than to overhaul incl all stuff)

are there any flat top round skirt pistons à la Ross to fit 4.010 bore? I could not find any ..

TX Team
Matt_G