Good morning,
I have started to put my Cleveland engine into pieces. I found that flow cross section of the intake manifold does not fit in size with those of the heads (up to 5mm step). I have attached photos from the heads. Does somebody know those (I was told that they were sold by Hall Pantera in the 80th)? I'm looking for the manifold matching with those heads. Any advice?
Head characteristic
• Intake valve 2.19 Inch
• Exhaust valve 1.71 Inch
• Intake port flow area: 2,07 x 1,68 inch
• Exhaust almost circular with 1.65 inch Diameter
Thanks for any advice or thoughts you might have.
Hartwig
Attachments
Original Post