Skip to main content

Reply to "Installing Brake Kit"

Have you checked them against the pictures in Halls catalog ?
Sounds like one of his set ups from reading the description.

I can not figure out where these six machined brackets go.

Has anyone installed a brake kit and can lend some assistance please?

I'm just getting into it, the half shafts have been pulled, the axle nut tool is in my possession, and I'm about to dig into it. The front wheels are on the ground and I'm ready to put 400 foot pounds of torque onto loosening the axle nuts. Carefully applying a lot of force!

The hole spacing on the rear upright, where the original caliper is bolted to, has smaller hole spacing distance than the hole spacing distance on the new calipers. So, I presume some combination of these machined mounting brackets is going to adapt the new caliper to the car.

Any clue who may have marketed this kit originally? Nicely etched word "DeTomaso" on the side of the black calipers, 4 pistons, curved vane ventilated rotors with aluminum hats. Any idea who to call for assistance on the phone? Any articles written on the subject? I have five years back of PI and POCA, so if anyone remembers an article, I'll look it up. Puzzling to me. It's always the details, eh? Thanks.[/QUOTE]
×
×
×
×