Reply to "Installing MSD Ignition"

I mounted the Blaster 3 above the original bolted to the firewall with bolts from the inside through the firewall. This location allows the coil wire to reach the dist. Then I located the tach adapter on the orig plate mounted to the firewall (bolt it don't just stick it with the existing 2 sided tape). The volt. reg and solinoid are in the original location, I kept the balast resitor bolted to plate but did not use. The 6A box is mounted below the original plate with 4 screws that go through the firewall from inside out. Seems to work good so far even with a few HOT times with the swiril and over flow tanks. Make sure that you get the right dist #8577 (the smaller one) or your cover won't fit. Sorry no pic's yet.