Reply to "Lowered Battery Box"

...I manufactured and installed My Battery Box. The only way to get the Battery in was to disconnect the clutch line and Loosen the Master Clutch Cylinder Bolts (2) almost all the way off; so the cylinder can be 'Swung' at and angle for clearence. It is NOT neccessary to disconnect the cylinders 'Push Rod'!! To make it much easier to get to the backside of the bolts to loosen them, I cut a 2.0 inch hole on the side of the foot/pedal box, using a holesaw. Now I can reach in 3 inches with a box end wrench and access the bolts without ever having to craw under the dash! The hole is then covered with a 2.5" X 2.5" Stainless Steel Plate and four SS screws, one in each corner. In My case, the cables Do NOT go through the Side of the Box, they come over the top of the battery from their original port in the Bulkhead above the Passenger footwell. You will have to Remove the TERMINALS from Your Cable Ends in order to get the Cables moved clear. Good-Luck with it!...