Reply to "Mangusta Clutch Slave Cylinder"

RyGuy,

For big pic's.....with Winders, you can right click on the picture and see if there is an option to "resize pictures" already. If so, you can select "medium size" and either make a new copy (smaller) and leave the original alone...or don't make a copy and do resize the original!

If you do not have the resizer.....go see Bill Gates.....! Microsoft.com will have an "add-on" that you can download.

If you have a Mac......see Google.....

In my picture of the original above, I didn't post the other side....but on some units (see ebay!) you will see a tab for a spring connection. This was removed from my unit.....at some point in time......

OTHERWISE....it looks like the Ferarri unit should do the trick! Probably a steel unit, but that is fine. You may still need to remove that tab..... depends on what gets in the way!

Rigging???? Can ya be more specific?

WHat you do want to look for is the rod that fits to the piston and the throw out arm on the ZF. You will need to get the ball end and the lock nuts...and xfer them over to the new unit..... Rod may or may not need to be shortened.....

Adjustment is easy. Adjust so there is about 1/16-1/8" of free play between piston at rest, and making the throw out bearing contact the fingers on the pressure plate.

You can check this by using a large pliers or such to move the arm.....adjust free play accordingly using lock nuts on ball pivot.

I hope this is more clear!?

Steve