Reply to "Melted through wiring - advice needed"

garvinoMember

Larry,

The light blue wire heading towards the engine harness area after the white quick connector (still near main fuse box under the dash) shows no evidence of melting (at least as much of it as I can see before it disappears into the loom). As you said, hopefully I dodged that bullet.

As for pulling the dash, I was just concerned about other wires that may have been secondary casualties that run next to and through the light blue wire.

Thanks for the input Bosswrench. I kind of figured that the dashboard, like a lot of parts on the Pantera, probably is no to bad to pull but a bearcat to put it back in. I also have a single pod dash versus the double pod - so I did not know if that added any different steps or challenges.

If I pull the dash maybe this would be a good time to add an extra AC vent in the dash (I think David B did that in his GT5 - if memory serves me correct) and also cover it leather.

Thanks again for all the advice. It is much appreciated.

Devin

3/28/158:38 AM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...