Reply to "Need to Wire tie the ring gear bolts"

bosswrenchMember

The short stock plastic vent hose often winds up dumping any collected stuff etc in front of the right rear tire. Many fastidious owners tap the hole for a right angle dash-4 AN fitting and run a ss hard line straight back to the center-rear of the transaxle. If you have a small lathe, you could cut the threads off such an AN fitting and lightly press it in the existing hole. Or, route a longer plastic hose to the same area. There's zero pressure in the cases so AN fittings & lines are enormous overkill, however 'racecar' they may appear.

3/25/172:59 PM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...