Reply to "Oilpan"

Hold that order!!!

I stated a LONG time ago that the Goose pan that I designed with Aviad was WRONG!

Due to the fact that my engine had been lifted (frame mounts modified!!!) and once the mounts were returned to stock height (so I could fit the stock air cleaner...duh!!) that oil pan sticks down below the frame rails and becomes the target of every driveway ramp you try to finagle over!!!

See post several down of 8 qt pan sticking down below frame rails!

When I contacted Aviad about changing the design, by shortening it 1.75" or so, I was told no.......

SOOOOO, I went to Armando Oil Pans and had him make me up the custom pan that I wanted.

Now, because shtuff happens....perhaps Aviad is making a different pan......but I would check on the depth dimension and see where that puts the bottom of your pan when measured from the oil pan rail on the engine....

My Armando pan is full length, fully baffled, with windage provisions, relieved slightly for starter removal, has front and rear drains, and has bung at front for installing oil temp sensor.

Have attached picture(s)....