Monday night: Seams are caulked and silver paint has been applied. The metallic in the paint was a bit more of a mess (flying around!) than I had anticipated and it is a little more metallic than I had thought.....oh well, it does what I wanted it to....brighten up an otherwise dark place!
Left side:
Right side:
Center: Now I can see a lot more of the welding and problem areas. Of course put an engine in here and poof! That all changes! ....let's not forget about the heat barrier stuff that needs to go all over the place too......won't be able to see anything of this!!! 
Left Hand lower corner of chassis to center spine area where road smegma tends to collect! (Sorry for the blurry photo!)
Right Hand lower corner...note the small hole....this was one of my rust holes that I found. Not worth trying to repair from any angle in here! So figure if I hit any large quantities of water, it will allow it to drain out.... That's the story! The other hole encountered was even smaller (and in a less accessible spot) and was covered by caulk in the end. This is what painting the compartment a light color was all about. Being able to see details more easily...
Of course now every part I bolt back on will look like crap!
Off to the showers again!
Steve
