quote:I also need that strange bush that sits
Trunnion bearing. Stocker is pretty well done for after 35 years.
All the vendors have it.
Quella does something different on his restorations. He removes the shaft and welds a larger pipe over the area where the trunnion is. He then turns that new o.d. down to fit properly inside a large heim joint.
No slop, but a bit problematic for keeping lubricated.
A local owner bought the axles just late last year. I recall the bill was just under $400. Doubt it has risen since them.
As for tolerance, I do not have measurements of the set I bought, but I am quite sure Steve had them made for a proper fit.
Larry
