Group 4 Tail Lights getting prepped for install.
I am using the Pantera Electronics light modules, so the surface of the buckets doesn't have to be "ultra reflective". The insides were much shinier when I got them, but they got a light "soda blast" to provide a clean surface for the finish.
The Jon Haas (P-E) setup runs the wires through each of the bucket light sockets, so in this case, they are not required. I expect to do some work to seal off the insides as I run the wires through the back of the buckets. Probably use heat shrink, or some other technique.
I am pretty excited about this upgrade. It should be a pretty easy swap. I have some matching connectors to the stock harness coming from Jon, so once I get the buckets wired up, and the light assemblies installed in the buckets, the swap from the US lights, to the Group 4 configuration should be a snap.
Fingers crossed!
Rocky