Here is the next puzzle to solve…
The black bracket it’s on the rear of the power steering… once you put everything in place and attach the front 2 bolts you can feel the holes through the back, there’s like a 1 inch slot on the top, but you can stick a finger in… One finger only!
the instructions it says mark the holes for the bracket and drill the holes…
I couldn’t do it with everything in place..
paint on my fingertip.. no… not enough penetration into the hole…
so put everything together and put it in place where it’s supposed to be then unbolted that bracket and tried to the best of my abilities to leave it in place exactly it’s supposed to be and unbold the rest of the steering and removed it In the hope the bracket stayed in position! It’s held by the 2 uprights I trimmed before… about 92mm apart… if I touch the uprights the bracket moves… not falling out but moving… so did the whole procedure again and this time I just use the red can to get the outlines and hopefully the hole…
now while writing this and looking at the pic I should have made a paper template… that might be another solution! Maybe more accurate than my abstract painting!
up to this point I had the Powersteering in and out approximately 10 times!
