Reply to "Rear Trunk Latch"

Note the location of the locking pin and how it differs between the two pictures. This different location will likely work just fine, as it is matched to the housing. But it does indicate they are not the same.

Also, the actuating pin on the back of the lock cylinder has different styles and the German photo leaves one guessing as to what it looks like.

Additionally, the lock cylinder mounts at an angle to the mounting plate on our Pantera's, and photographs of these similar locks often fail to clearly show if that angle is the same with a Pantera lock. It may be possible to work around an incorrect angle by using a tapered shim during installation, as long as the result protrudes far enough.

Larry