Brooke,
Its 18ga ..very hard to bend .. its only 22" wide .. I added 2 cross members front and rear because some strength is lost with flat bottom pans .. have not mounted the pedals yet .. but there was a short section below the pedal area that had to be left in place because it was a structural member that I didnt remove.
My other car 9138 has minumal cross braces. I kind of used that car as my guide making these pans. 9138 has factory dropped pans the entire floor also. 7" from the door sill.
Ron
Ron
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.