I cut a small C notch in my gear plate to access the third bolt.
I used the template at Pantera Place for two of the bolt holes then measured the third.
I had to grind down part of the metal guide bump for the bolt to go through but it worked fine.
I am using no spacers on the screws. I tapped the holes in the motor for the screws to go into so there are no nuts used either.
PANTERA INTERNATIONAL
A DE TOMASO CAR CLUB
Presents the De Tomaso Forums
The On-Line Meeting Place for De Tomaso Owners and Enthusiasts From Around the World
Clicking on the banner will take you to the sponsor's website.