Reply to "The headlight motor is too hot to touch"

ok try:
- + power OFF the bat
- light switch ON (full for head light)
- ignition into run

then connect to bat+ lossely step on step..see what happens,
- first it goes up and up..and should be limited by swich fisrt..then by end point screw as applies
- bat+ off at any up going position or end point up
- then light switch OFF
- bat+ again temp (on/off etc.) on it goes down and down and then does it stop per down switch OR per limiter screw?

(this is by the way I did tune end position for up and down)

Matthias
×
×
×
×